Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
undo isis ipv6 lfa-backup
The interface is disabled from participating in the LFA calculation.
----End

7.19.4 Checking the Configurations

After IPv6 IS-IS Auto FRR is configured, you can check backup route information and traffic
protection types of IS-IS.
Prerequisites
IPv6 IS-IS Auto FRR has been configured.
Procedure
l
l
----End
Example
Run the display isis route command, and you can view information about the outbound interface
and next hop of the backup route. The configuration result is as follows:
<HUAWEI> display isis route ipv6 3::3 verbose
IPV6 Dest
Admin Tag
Issue 02 (2014-09-30)
NOTE
By default, an IS-IS interface participates in LFA calculation.
Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6
[ verbose | [ level-1 | level-2 ] | ipv6-address [ prefix-length ] ]
information about the primary and backup links after IPv6 IS-IS Auto FRR is enabled.
Run the display isis spf-tree [ systemid systemid | dname dname ] [ [ level-1 | level-2 ] |

*

ipv6 | verbose ] [ process-id | vpn-instance vpn-instance-name ] command to check the
traffic protection type of IPv6 IS-IS Auto FRR.
ISIS(100) Level-1 Forwarding Table
----------------------------------
: 3::3/128
: -
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Route information for ISIS(100)
-------------------------------
Src Count : 1
7 IS-IS Configuration
*
command to check
Cost : 10 Flags: A/L/-
Priority: Medium
627