Huawei Quidway NetEngine80E Configuration Manual page 335

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospf [ process-id ]
The OSPF process view is displayed.
Step 3 Run:
opaque-capability enable
The Opaque LSA capability is enabled.
Step 4 Run:
hostname hostname
An OSPF dynamic hostname is configured.
----End
Checking the Configurations
Run either of the following commands to check OSPF hostname information:
l
l
l
l
Run the display ospf hostname-table command to check information about OSPF dynamic
hostnames.
<HUAWEI> display ospf hostname-table
Issue 02 (2014-09-30)
Configure an IP address for each interface to ensure that neighboring routers can use the
IP addresses to communicate with each other.
Configure basic OSPF functions.
Enable the Opaque LSA capability.
NOTE
If you specify hostname in this command, hostname is advertised as the dynamic hostname. If no
hostname is specified in this command, the device name specified in the sysname command is advertised
as the dynamic hostname.
display ospf hostname-table
display ospf [ process-id ] peer [ interface-type interface-number | interface-name ]
hostname hostname
display ospf [ process-id ] lsdb [ { router | network | summary | asbr | ase | nssa | opaque-
link | opaque-area | opaque-as } [ link-state-id ] ] hostname hostname [ age { min-
value min-age-value | max-value max-age-value }
display ospf [ process-id ] lsdb [ { brief | [ { router | network | summary | asbr | ase |
nssa | opaque-link | opaque-area | opaque-as } [ link-state-id ] ] [ originate-router
[ advertising-router-id ] | self-originate ] [ age { min-value min-age-value | max-value
*
max-age-value } ] [ resolve-hostname ] } ]
OSPF Process 1 with Router ID 1.2.3.4
Hostname table information
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPF Configuration
*
]
310