Huawei Quidway NetEngine80E Configuration Manual page 830

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv4-family unicast
The BGP-IPv4 unicast address family view is displayed.
Step 4 Run:
supernet unicast advertise enable
The BGP device is enabled to advertise BGP supernet unicast routes to BGP peers.
----End
Checking the Configurations
After you configure a BGP device to advertise BGP supernet unicast routes, check whether the
configuration takes effect.
l
l
# Run the display bgp routing-table command to view received BGP supernet unicast routes.
<HUAWEI> display bgp routing-table
BGP Local router ID is 1.1.1.2
Status codes: * - valid, > - best, d - damped,
Total Number of Routes: 1
# Run the display bgp routing-table network command to view information about a specified
BGP supernet unicast route advertised to BGP peers.
<HUAWEI> display bgp routing-table 1.1.1.1
BGP local router ID : 1.1.1.2
Local AS number : 100
Paths:
BGP routing table entry information of 1.1.1.1/32:
From: 1.1.1.1 (11.1.1.1)
Route Duration: 00h03m12s
Relay IP Nexthop: 11.1.1.1
Relay IP Out-Interface: Ethernet0/0/1
Original nexthop: 1.1.1.1
Qos information : 0x0
AS-path Nil, origin igp, MED 0, localpref 100, pref-val 0, valid, internal, best,
select, pre 20, IGP cost 10
Advertised to such 1 peers:
Issue 02 (2014-09-30)
Run the display bgp routing-table command to check BGP supernet unicast routes.
Run the display bgp routing-table network command to check information about a
specified BGP supernet unicast route advertised to BGP peers.
h - history,
Origin : i - IGP, e - EGP, ? - incomplete
Network
*>i 1.1.1.1/32
1 available, 1 best, 1 select
15.1.1.1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
i - internal, s - suppressed, S - Stale
NextHop MED
1.1.1.1 0
8 BGP Configuration
LocPrf PrefVal Path/Ogn
100 0 ?
805