Huawei Quidway NetEngine80E Configuration Manual page 207

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run the following command as required:
l Run:
l Run:
l Run:
l Run:
l Run:
----End
Result
The following section describes the changes in RIP neighbor relationships and data traffic
volume during the upgrade from RIP-1 to RIP-2 with authentication.
Scenario 1: Consider the security upgrade is required in the topology mentioned in
3-1
configured with default version.
Figure 3-1 RIP on P2P link
Router A
Issue 02 (2014-09-30)
rip authentication-mode simple { plain plain-text | [ cipher ] password-key }
Simple authentication is configured for RIP-2 packets.
rip authentication-mode md5 usual { plain plain-text | [ cipher ] password-key }
MD5 usual authentication is configured for RIP-2 packets.
rip authentication-mode md5 nonstandard
plain-text | [ cipher ] password-key } key-id } }
MD5 nonstandard authentication is configured for RIP-2 packets.
rip authentication-mode hmac-sha256 { plain plain-text | [ cipher ] password-
key } key-id
hmac-sha256 authentication is configured for RIP-2 packets.
rip authentication-mode keychain keychain-name
Keychain authentication is configured for RIP-2 packets.
NOTE
The MD5 type must be specified if MD5 authentication is configured. The usual type supports private
standard authentication packets, and the nonstandard type supports IETF standard authentication packets.
which contains one P2P link. Security upgrade between Router A and Router B are
interface1
interface2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
{ keychain keychain-name | { { plain
Router B
3 RIP Configuration
Figure
182