Huawei Quidway NetEngine80E Configuration Manual page 611

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Issue 02 (2014-09-30)
a. Run
acl ipv6 name acl-name [ number acl-number2 ] [ match-order
{ auto | config } ]
The basic ACL view is displayed.
b. Run
rule [ rule-id ] { deny | permit } protocol [ source { source-
ipv6-address prefix-length | source-ipv6-address/prefix-length
| any } | time-range time-name ]
A rule is configured for the advanced ACL.
When a filtering policy of a routing protocol is used to filter routes:
– If the action specified in an ACL rule is permit, a route that matches
the rule will be received or advertised by the system.
– If the action specified in an ACL rule is deny, a route that matches the
rule will not be received or advertised by the system.
– If a route has not matched any ACL rules, the route will not be received
or advertised by the system.
– If an ACL does not contain any rules, all routes matching the route-
policy that references the ACL will not be received or advertised by
the system.
– If the ACL referenced by the route-policy does not exist, all routes
matching the route-policy will be received or advertised by the
system.
– In the configuration order, the system first matches a route with a rule
that has a smaller number and then matches the route with a rule with
a larger number. Routes can be filtered using a blacklist or a whitelist:
Route filtering using a blacklist: Configure a rule with a smaller
number and specify the action deny in this rule to filter out the
unwanted routes. Then, configure another rule with a larger number in
the same ACL and specify the action permit in this rule to receive or
advertise the other routes.
Route filtering using a whitelist: Configure a rule with a smaller
number and specify the action permit in this rule to permit the routes
to be received or advertised by the system. Then, configure another
rule with a larger number in the same ACL and specify the action
deny in this rule to filter out unwanted routes.
– ipv6 import-route isis level-2 into level-1 [ tag tag | filter-policy ipv6-prefix
*
ipv6-prefix-name ]
Routes in the Level-2 area and other Level-1 areas that meet the specified
conditions are leaked into the local Level-1 area based on the prefix list.
– ipv6 import-route isis level-2 into level-1 [ tag tag | filter-policy route-policy
route-policy-name ]
Routes in the Level-2 area and other Level-1 areas that meet the specified
conditions are leaked into the local Level-1 area based on the route policy.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
7 IS-IS Configuration
*
586