Huawei Quidway NetEngine80E Configuration Manual page 670

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure an IP address for each interface.
This example assumes that you know the configuration method and no details are provided here,
for detailed configurations, see configuration files in this example.
Step 2 Configure basic IS-IS functions.
# Configure Router A.
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface Pos 1/0/0
[RouterA-Pos1/0/0] isis enable 1
[RouterA-Pos1/0/0] quit
# Configure Router B.
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface Pos 1/0/0
[RouterB-Pos1/0/0] isis enable 1
[RouterB-Pos1/0/0] quit
# Configure Router C.
[RouterC] isis 1
[RouterC-isis-1] network-entity 10.0000.0000.0003.00
[RouterC-isis-1] quit
[RouterC] interface Pos 1/0/0
[RouterC-Pos1/0/0] isis enable 1
[RouterC-Pos1/0/0] quit
[RouterC] interface Pos 2/0/0
[RouterC-Pos2/0/0] isis enable 1
[RouterC-Pos2/0/0] quit
[RouterC] interface Pos 3/0/0
[RouterC-Pos3/0/0] isis enable 1
Issue 02 (2014-09-30)
Enable IS-IS on each router, configure the levels of routers, and specify an NET.
Set RouterA and RouterC to authenticate Hello packets in specified mode and with the
specified password.
Check the IS-IS database and the routing table of each router.
Area addresses of Router A, Router B, Router C and Router D
Levels of Router A, Router B, Router C, and Router D
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
645