Lldp - Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual

• Identification Method
Shows the method with which the DHCP client is identified.
– Remote ID
– Circuit ID
• Identification Value
Shows the value that is assigned to the identification method.
• Allocation Method
Shows whether the IPv4 address was assigned statically or dynamically. You
configure the static entries in "System > DHCP > Static Leases".
• Binding State
Shows the status of the assignment.
– Associated
– not used
– probing
– unknown
• Expire Time
Shows how long the assigned IPv4 address is still valid. When half the period of
validity has elapsed. the DHCP client can extend the period of the assigned IPv4
address. When the entire time has elapsed, the DHCP client needs to request a new
IPv4 address.
4.3.8

LLDP

Status of the neighborhood table
This page shows the current content of the neighborhood table. This table stores the
information that the LLDP agent has received from connected devices.
You set the interfaces via which the LLDP agent receives or sends information in the
following section: "Layer 2 > LLDP".
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
Shows the remote ID of the DHCP client.
Shows the circuit ID of the DHCP client.
The assignment is used.
The assignment is not used.
The assignment is being checked.
The status of the assignment is unknown.
Configuring with Web Based Management
4.3 "Information" menu
91