Terminal Descriptions - Delta C2000 series User Manual

Chapter 8 Optional Cards |C2000 Series
EMC-PG01O

Terminal descriptions

Set by Pr.10-00~10-02
Terminals
VP
DCM
PG1
A1, /A1, B1,
/B1, Z1, /Z1
A2, /A2,
PG2
B2, /B2
V+, V+
V-
PG OUT
A/O, B/O, Z/O
Note 1: Open Collector application, input current 5~15mA to each set then each set needs one pull-up resistor.
5V
12V
24V
PG1 Wiring Diagram
Output voltage for power
Max. output current: 200mA
Common for power and signal
Encoder Input signal (Line Driver or Open Collector)
Open Collector Input Voltage: +5V/+12V
It can be 1-phase or 2-phase input.
Max. output frequency: 300kP/sec
Pulse Input Signal (Line Driver or Open Collector)
Open Collector Input Voltage: +5~+24V
It can be 1-phase or 2-phase input.
Max. output frequency: 300kP/sec.
Needs external power source for PG OUT circuit.
Input voltage of power:+12V ~ +24V
Input voltage for the negative side
PG Card Output signals has division frequency function: 1~255 times.
On the open collector's output signal, add a high-pull resistor on the external
power V+ ~ V- (e.g. power of PLC) to prevent the interference of the receiving
signal. Max. 。[Three pull-up resistor are included in the package (1.8kW/1W)]
Max. output frequency: 300KP/Sec
Recommanded pull-up resistor: above100~220Ω, 1/2W
Recommanded pull-up resistor: above 510~1.35kΩ, 1/2W
Recommanded pull-up resistor, above1.8k~3.3kΩ, 1/2W
When wiring in this way, if there
A1, B1 and Z1,LED lights is OFF.
if A1, B1 and Z1 have no signals, LED lights is ON.
Descriptions
:
+5V/+12V±5% (use FSW3 to switch +5V/+12V)
Vp
Ext Pull
high RES
ABZ1
4.7kΩ
ABZ1
ABZ1
4.7kΩ
ABZ1
DCM
a signal on EMC-PG01's
8-8
Vp
DCM
Vp
DCM