Delta C2000 series User Manual page 168

d. Value Length: Click on the drop down to choose 16bits or 32 bits. Then click OK to accept the
setting or click Cancel to abort.
e. Main Scale & Sub Scale: In order to divide the whole scale into equal parts, key in the numbers of
your choices for main scale and sub scale.
f. Maximum value & Minimum Value are the numbers on the two ends of a scale. They can be
negative numbers but the input numbers are limited by value.
g. Follow the Scale setting mentioned above; you will have a scale as shown below.
4. Bar Graph setting
a. Related Device: Choose the VFD Communication Port that you need.
b. Direction Setting: Click on the drop down menu to choose one of the following directions: From
Bottom to Top, From Top to Bottom, From Left to Right or From Right to Left.
c. Maximum Value & Minimum Value: They define the range covered by the maximum value and
minimum value. If a value is smaller than or equal to the minimum value, then the bar graph will be
blank. If a value is bigger or equal to the maximum value, then the bar graph will be full. If a value is
between minimum and maximum value, then the bar graph will be filled proportionally.
5. Button : Currently this function only allows the Keypad to switch pages, other functions are not yet
available. Text input function and Image inserted functions are not yet supported.
Double click on
a. <Button Type> allows you set up buttons' functions. But Page Jump is the only supported function
currently.
b. Page Jump setting: After you choose the Page Jump function in the drop down list, you will see this
Page Jump Setting Menu
c. <Function Key> allows you to assign functions to the following keys on the KPC-CC01 keypad: F1,
F2, F3, F4, Up, Down, Left and Right. Please note that the Up and Down keys are locked by
TPEditor. These two keys cannot be programmed. If you want to program Up and Down keys, go to
Tool Function Key Settings (F) Re-Define Up/Down Key(R).
:
to open set up window.
10-19
Chapter 10 Digital Keypad |C2000