Receiving And Inspection; Nameplate Information; Chapter 1 Introduction; Group - Delta C2000 series User Manual

Receiving and Inspection

After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure
that the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals "R/L1, S/L2,
T/L3" and output terminals"U/T1, V/T2, W/T3" are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPC-CC01). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.

Nameplate Information

Inpu t Volta ge/Current
Output Voltage /Cu rren t
Encl osure type (IPXX)
AC Dri ve Mode l
Frequ ency Range
Firmware Versio n
Certifications
Serial Number

Chapter 1 Introduction

MODEL:VFD007C43A
INPUT:
Normal Duty: 3PH 380-4 80V 50/60Hz 4.3A
Heavy Duty: 3PH 38 0-4 80V 50/60Hz 4.1A
OUTPUT:
Normal Duty: 3PH 0-480 V 3A 2.4KVA 1HP
Heavy Duty: 3PH 0- 480 V 2.9A 2.3KVA 1 HP
FREQUENCY RANGE:
Normal Duty: 0-600Hz
Heavy Duty: 0-300Hz
VX.XX
Version:
007 C4 3A7T9300 002
DELTA E LEC TRONIC S. INC .
MAD E IN XXXXXXX
1-1
Chapter 1 Introduction|C2000 Series