Delta C2000 series User Manual page 298

Settings Read only
Pr.05-26~05-29 records the amount of power consumed by motors. The accumulation begins
when the drive is activated and record is saved when the drive stops or turns OFF. The amount of
consumed watts will continue to accumulate when the drive activate again. To clear the
accumulation, set Pr.00-02 to 5 then the accumulation record will return to 0.
Accumulative Motor Operation Time (Min)
Settings 00~1439
Accumulative Motor Operation Time (day)
Settings 00~65535
Pr. 05-31 and Pr.05-32 are used to record the motor operation time. To clear the operation time, set
Pr.05-31 and Pr.05-32 to 00. Operation time shorter than 60 seconds will not be recorded.
Induction Motor (IM) and Permanent Magnet Motor Selection
Settings 0: Induction Motor
1: Permanent Magnet Motor
Full-load current of Permanent Magnet Motor
Settings 0.00~655.35 Amps
Rated Power of Permanent Magnet Motor
Settings 0.00~655.35 kW
Rated speed of Permanent Magnet Motor
Settings 0~65535 rpm
Pole number of Permanent Magnet Motor
Settings 0~65535
Inertia of Permanent Magnet Motor
Settings 0.0~6553.5 kg.cm
This parameter setting is defined in kg-cm
the chart below. (Delta's motor inertia chart is for reference purpose only.)
Chapter 12 Description of Parameter Settings|C2000 Series
2 2
(0.0001kg.m )
2
. If this measure is not familiar to you, please refer to
12-91
Factory Setting: 0
Factory Setting: 0
Factory Setting: 0
Factory Setting: 0.00
Factory Setting: 0.00
Factory Setting: 2000
Factory Setting: 10
Factory Setting: 0.0