Ptc (Positive Temperature Coefficient) Detection Selection; Ptc Level; Frequency Command For Malfunction; Output Frequency At Malfunction - Delta C2000 series User Manual

Fault Code
83: OPHL Vphase output phase loss
84: OPHL Wphase output phase loss
85~100: Reserved
101: CGdE CANopen software disconnect1
102: CHbE CANopen software disconnect2
103: CSYE CANopen synchronous error
104: CbFE CANopen hardware disconnect
105: CIdE CANopen index setting error
106: CAdE CANopen slave station number
setting error
107: CFrE CANopen index setting exceed limit
108~110: Reserved
111: InrCOM Internal communication overtime
error

PTC (Positive Temperature Coefficient) Detection Selection

Settings 0: Warn and keep operating
Pr.06-29 setting defines how the will drive operate after PTC detection.

PTC Level

Settings 0.0~100.0%
It needs to set AVI/ACI/AUI analog input function Pr.03-00~03-02 to 6 (P.T.C. thermistor input
value).
It is used to set the PTC level, and the corresponding value for 100% is max. analog input value.

Frequency Command for Malfunction

Settings 0.00~655.35Hz
When malfunction occurs, use can check the frequency command. If it happens again, it will
overwrite the previous record.

Output Frequency at Malfunction

Settings 0.00~655.35Hz
When malfunction occurs, use can check the current frequency command. If it happens
again, it will overwrite the previous record.
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
12-104
Chapter 12 Description of Parameter Settings|C2000 Series
Bit0 Bit1 Bit2
current Volt. OL
●
●
Bit3 Bit4 Bit5
SYS FBK EXI
Factory Setting: 0
Factory Setting: 50.0
Factory Setting: Read only
Factory Setting: Read only
Bit6
CE
●
●
●
●
●
●
●
●