Delta C2000 series User Manual page 40

Chapter 3 Unpacking|C2000 Series
Secure the drive from the internal.
Loosen 18 of the M6 screws and remove the top
cover as shown in figure 2. Mount the cover (figure
1) back to the drive by fasten the M6 screws to the
two sides of the drive, as shown in figure 2.
Torque: 35~45kg-cm (30.38~39.06lb-in.)
Figure 1
Top cover (Use M12 screws)
Figure 2
Fasten 6 of the M6 screws back to the original position where it was removed. As shown in the figure:
Secure the drive from the external.
Loosen 8 of the M8 screws on the both sides and
place the 2 plates that were removed from the last
step. Fix the plates to rive by fasten 8 of the M8
screws. (As shown in figure below).
Torque: 150~180kg-cm (130.20~156.24lb-in.)
3-10