Delta C2000 series User Manual page 504

2. To control the slave address and corresponding station. For example, control 2 stations of
the slave (max. 8 stations synchronous control), if the station number is 21 and 22, set
D2000 and D2100 to 20 and 21 and then set D2200, D2300, D2400, D2500, D2600 and
D2700 to 0. The setting can be done via PLC software editor WPL, follow the steps shown:
Open WPL Editor > communication> Edit Register Memory(T C D)
When the "Register" window appears, click "Transmit".
When transmission window appear, select "read" and input the range D2000~D2799
then press enter. The value in D2000~D2799 will be read. If communication failed,
check the communication format (pre-defined PLC station is 2, 9600, 7N2, ASCII).
Insert the slave station for control. Set D2000 and D2100 to 20 and 21 then set D2200,
D2300, D2400, D2500, D2600 and D2700 to 0.
Click"Transmit" again. When transmission window appears, input the range
D2000~D2799 and enter. The value in D2000~D2799 will be write (If communication
error occur and display failed, it means PLC is not in "stop" status. The value can only
Chapter 16 PLC Function |C2000 Series
16-81