Delta C2000 series User Manual page 170

a. Related Device: There are two blank spaces to fill in, one is <Write> and another one is <Read>.
Input the numbers that you want to display and the corresponding numbers of a parameter and that
of a communication port. For example, input 012C to Read and Write Parameter P01-44.
b. OutLine Setting: The Frame setting, Font setting, Vertical Alignment and Horizontal Alignment are
the same as mentioned before. Click on the drop down menu and choose the setting that you need.
c. Function key: The setting here allows you to program keys on the keypad. Press the key on the
menu then the corresponding key on the keypad will start to blink, then press Enter to confirm the
setting.
d. Value Type & Value Length: These two factors influence the range of the Minimum and Maximum
Value of the Limit Setting. Please note that the corresponding supporting values for C2000 have to
be 16bits. The 32bits values are not supported.
e. Value Setting: This part is set automatically by the keypad itself.
f. Limit Setting: Input the range the security setting here.
g. For example, if you set Function Key as F1, Minimum Value as 0 and Maximum Value ias 4, then
press F1 on Keypad Then you can press Up and Down key on the keypad to increase or decrease
the value. Press Enter Key on the keypad to confirm your setting. You can also go to parameter
table 01-44 to verify if your input correctly the value.
9. Download TP Page
Link.
Then press Enter on the keypad and you will see the word "Waiting" on keypad's screen. Now choose a
page that you have created then go to Communication (M) Write to TP(W) to start downloading the
page to the keypad
When you see the word Completed on the keypad's screen, that means the download is done.
Then you can press ESC on the keypad to go back to the menu of the keypad.
Chapter 10 Digital Keypad
: Press Up or Down key on the keypad until you reach #13 PC
10-21
.
|C2000