Delta C2000 Series Manual

1-1 Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure that
the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals "R/L1, S/L2, T/L3"
and output terminals"U/T1, V/T2, W/T3" are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPC-CC01). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.
1-2 Nameplate Information
AC Drive Model
Input Vol tage/ Current
Output Volta ge/C urrent
Frequency Range
Fi rmware Version
Enclosure type (IPXX)
Ce rtif cations i
Serial Number
Chapter 1 Introduction
MOD E L:VFD0 07C43 A
INPU T:
Normal Duty: 3PH 380-480V 50/60Hz 4.3A
Heavy Duty: 3PH 380-480V 50/60Hz 4.1A
OUTPUT:
Normal Duty: 3PH 0-480V 3A 2.4KVA 1HP
Heavy Duty: 3PH 0-480V 2.9A 2 .3KVA 1HP
FREQU ENCY RA NGE:
Normal Duty: 0 -59 9Hz
Heavy Dut y: 0-300Hz
Ver si on:
VX.XX
007C43A7 T14300002
DE LTA EL E CTRONICS. INC .
MA DE IN XX XX XX X
1-1
Chapter 1 IntroductionC2000 Series