Descriptions Of Digital Keypad - Delta CFP2000 Series User Manual

Chapter 10 Digital KeypadCFP2000

10-1 Descriptions of Digital Keypad

KPC-CC01
Descriptions of Keypad Functions
Key
Start Operation Key
1.
2.
3.
Stop Command Key. This key has the highest priority in any situation.
1.
2.
3.
Operation Direction Key
1.
2.
ENTER Key
Press ENTER and go to the next level. If it is the last level then press ENTER to execute the
command.
ESC Key
ESC key function is to leave current menu and return to the last menu. It also functions as a
return key or cancel key in the sub-menu.
Press menu to return to main menu.
Menu content:
1. Parameter Setup
2. Quick Start
3. Application Selection List
4. Changed List
5. Copy Parameter
6. Fault Record
Communication Interface
RJ45 (socket), RS-485 interface
Communication protocol:
RTU19200, 8, N, 2
Installation Method
1. Embedded type and can be put flat on the surface of the control
box. The front cover is water proof.
2. Buy a MKC-KPPK model to do wall mounting or embedded
mounting. Its protection level is IP66.
3. The maximum RJ45 extension lead is 5 m (16ft)
4. This keypad can only be used on Delta's motor drive CFP2000.
It is only valid when the source of operation command is from the keypad.
It can operate the AC motor drive by the function setting and the RUN LED will be ON.
It can be pressed again and again at stop process.
When it receives STOP command, no matter if the AC motor drive is in operation or stop
status, the AC motor drive needs to execute "STOP" command.
The RESET key can be used to reset the drive after the fault occurs.
The reasons why the error cannot be reset:
a. Because the condition which triggers the fault is not cleared. When the condition is
cleared, the fault can be reset.
b. Because it's the fault status checking when power-on. When the condition is cleared,
re-power again, and the fault can be reset.
This key only controls the operation direction, and will NOT activate the drive. FWD:
forward, REV: reverse.
Refer to the LED descriptions for more details.
Descriptions
7. Language Setup
8. Time Setup
9. Keypad Locked
10. PLC Function
11. Copy PLC
12. Display Setup
10-2
13. Startup Menu
14. Main Page
15. PC Link
16. Start Wizard