Delta C2000 series User Manual page 348

Content Address
2102H
2103H
2104H
2105H
2106H
2107H
2108H
2109H
201AH
201BH
201CH
201DH
201EH
201FH
2116H
211BH
2200H
2201H
2202H
2203H
2204H
2205H
2206H
2207H
2208H
2209H
220AH
220BH
220CH
220DH
220EH
220FH
2210H
2211H
2212H
2213H
2214H
2215H
2216H
Chapter 12 Description of Parameter Settings|C2000 Series
Bit9 1: Master frequency controlled by analog signal
1: Operation command controlled by
Bit10
communication interface
Bit11 1: Parameter locked
Bit12 1: Enable to copy parameters from keypad
Bit13~15 Reserved
Frequency command (F)
Output frequency (H)
Output current (AXX.X.X)
DC-BUS Voltage (UXXX.X)
Output voltage (EXXX.X)
Current step number of Multi-Step Speed Operation
Reserved
Counter value
Power Factor Angle (XXX.X)
Output Torque (%)
Actual motor speed (rpm)
Number of PG feed back pulses
Number of PG2 pulse commands
Power output (X.XXX)
Multi-function display (Pr.00-04)
Max. opeartion frequency (Pr.01-00) or Max. user defined value
(Pr.00-26)
Display output current (A)
Display counter value of TRG terminal (c)
Display actual output frequency (H)
Display DC-BUS voltage (u)
Display output voltage of U, V, W (E)
Display output power angle of U, V, W (n)
Display actual motor speed kW of U, V, W (P)
Display motor speed in rpm estimated by the drive or encoder
feedback (r00: positive speed, -00: negative speed)
Display positive/negative output torque in %, estimated by the
drive (t0.0: positive torque, -0.0: negative torque)
Display PG feedback (as NOTE 1)
Display PID feedback value after enabling PID function in % (b)
Display signal of AVI analog input terminal, 0-10V corresponds
to 0-100% (1.) (as NOTE 2)
Display signal of ACI analog input terminal, 4-V20mA/0-10V
corresponds to 0-100% (2.) (as NOTE 2)
Display signal of AUI analog input terminal, -10V~10V
corresponds to -100~100% (3.) (as NOTE 2)
Display the IGBT temperature of drive power module in
Display the temperature of capacitance in
The status of digital input (ON/OFF), refer to Pr.02-12 (as
NOTE 3)
The status of digital output (ON/OFF), refer to Pr.02-18 (as
NOTE 4)
Display the multi-step speed that is executing (S)
The corresponding CPU pin status of digital input (d.) (as NOTE
3)
The corresponding CPU pin status of digital output (O.) (as
NOTE 4)
Number of actual motor revolution (PG1 of PG card) (P.) it will
start from 9 when the actual operation direction is changed or
keypad display at stop is 0. Max. is 65535 (P.)
Pulse input frequency (PG2 of PG card)(S.)
12-141
Function
o
C (i.)
o
C (c.)