Source Of The Operation Command （Auto）; Stop Method - Delta C2000 series User Manual

6: CANopen communication card
7: Reserved
8: Communication card (no CANopen card)
It is used to set the source of the master frequency in AUTO mode.
Pr.00-20 and 00-21 are for the settings of frequency source and operation source in AUTO mode.
Pr.00-30 and 00-31 are for the settings of frequency source and operation source in HAND mode.
The AUTO/HAND mode can be switched by the keypad KPC-CC01 or multi-function input terminal
(MI).
The factory setting of frequency source or operation source is for AUTO mode. It will return to
AUTO mode whenever power on again after power off. If there is multi-function input terminal used
to switch AUTO/HAND mode. The highest priority is the mutli-function input terminal. When the
external terminal is OFF, the drive won't receive any operation signal and can't execute JOG.
Source of the Operation Command （AUTO）
Settings 0: Digital keypad
1: External terminals. Keypad STOP disabled.
2: RS-485 serial communication. Keypad STOP disabled.
3: CANopen card
4: Reserved
5: Communication card (not includes CANopen card)
It is used to set the source of the operation frequency in AUTO mode.
When the operation command is controlled by the keypad KPC-CC01, keys RUN, STOP and JOG
(F1) are valid.

Stop Method

Settings 0: Ramp to stop
1:Coast to stop
The parameter determines how the motor is stopped when the AC motor drive receives a valid stop
command.
Freq uen cy
Output
Frequenc y
Moto r
Ro tatio n
Spe ed
Oper atio n
RUN
Co mmand
Chapter 12 Description of Parameter Settings|C2000 Series
Ou tp ut
Freq uenc y
Moto r
Ro tatio n
Spe ed
Time
Stops acc ording t o
Oper atio n
deceler ation time
STOP Co mmand
Ra mp to Stop and Co ast to Sto p
12-13
Freq uen cy
Free running
to stop
RUN
STOP
Factory Setting: 0
Factory Setting: 0
Time