Delta C2000 series User Manual page 140

Slot 3
Slot 2 Slot 1
[Figure 3]
[Figure 5]
Communication Parameters for VFD-C2000 Connected to Ethernet
When VFD-C2000 is connected to Ethernet network, please set up the communication parameters
for it according to the table below. The Ethernet master is only able to read/write the frequency word
and control word of VFD-C2000 after the communication parameters are set.
Parameter
(Dec)
Source of frequency
P00-20
command setting
Source of operation
P00-21
command setting
Decoding method for
P09-30
communication
P09-75 IP setting
P09-76 IP address -1
P09-77 IP address -2
P09-78 IP address -3
P09-79 IP address -4
P09-80 Netmask -1
P09-81 Netmask -2
P09-82 Netmask -3
P09-83 Netmask -4
P09-84 Default gateway -1
P09-85 Default gateway -2
P09-86 Default gateway -3
P09-87 Default gateway -4
[Figure 4]
Function Set value (Dec)
8-25
Chapter 8 Optional Cards |C2000 Series
The frequency command is controlled by
8
communication card.
The operation command is controlled by
5
communication card.
The decoding method for Delta AC motor
0
drive
0 Static IP(0) / Dynamic distribution IP(1)
192 IP address 192.168.1.5
168 IP address 192.168.1.5
1 IP address 192.168.1.5
5 IP address 192.168.1.5
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
0 Netmask 255.255.255.0
192 Default gateway 192.168.1.1
168 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
Explanation