Delta C2000 series User Manual page 417

Display Fault code
Fault
PWR
Power RST OFF
Fault
oL
Inverter oL
Fault Fault
EoL2 EoL1
Thermal relay 1 Thermal relay 2
Fault
EoL2
Thermal relay 2
Fault Fault
EoL2 oH3
Motor over heat Thermal relay 2
Fault Fault
ot1 EoL2
Thermal relay 2 Over torq ue 1
Fault Fault
EoL2 ot2
Thermal relay 2 Over torq ue 2
Fault Fault
EoL2 uC
Thermal relay 2 Under to rque 1
Fault Fault
EoL2 LMIT
Thermal relay 2 Limit Error
Fault Fault
cF1 EoL2
EEPROM write Err Thermal relay 2
0014H Power RST off
Overload. The AC motor drive detects
excessive drive output current.
NOTE: The AC motor drive can
0015H
withstand up to 150% of the rated current
for a maximum of 60 seconds.
Electronics thermal relay 1 protection
0016H
Electronics thermal relay 2 protection
0017H
Motor overheating
The AC motor drive detects that the
0018H
internal temperature exceeds
Pr.06-30 (PTC level)
These two fault codes will be displayed
when output current exceeds
001AH
the over-torque detection level (Pr.06.07
or Pr.06.10) and exceeds
over-torque detection(Pr.06.08 or
001BH
Pr.06.11) and it is set 2 or 4 in
Pr.06-06 or Pr.06-09.
001CH Low current
001DH Limit error
Internal EEPROM can not be
001EH programmed.
15-25
Chapter 15 CANopen Overview |C2000 Series
Description
CANopen
CANopen fault
fault code register
(bit 0~7)
FF02H 2
2310H 1
2310H 1
2310H 1
FF20H 1
8311H 3
8311H 3
8321H 1
7320H 1
5530H 5