Match Ip Address - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
mac access-list extended NAME [NUMBER]
no mac access-list extended {NAME | NUMBER}
Parameters
NAME
NUMBER
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the MAC access-list configuration mode and use the permit or deny command
to specify the entries. The name must be unique among all access lists. The characters of the name are
case sensitive. If the access list number is not specified, the biggest unused number in the range of the
MAC access list numbers will be assigned automatically.
Example
This example shows how to enter the MAC access list configuration mode for a MAC access list named
"daily profile".
Switch# configure terminal
Switch(config)# mac access-list extended daily-profile
Switch(config-mac-ext-acl)#

4-14 match ip address

This command is used to associate an IP access list for the configured sub-map. The no form of this
command removes the match entry.
match ip address {ACL-NAME | ACL-NUMBER}
no match ip address
Parameters
ACL-NAME
ACL-NUMBER
Default
None.
Specifies the name of the MAC access-list to be configured. The
maximum length is 32 characters.
(Optional) Specifies the ID number of the MAC access list, For
extended MAC access lists, this value is from 6000 to 7999.
Specifies the name of the ACL access list to be configured. The name
can be up to 32 characters.
Specifies the number of the IP ACL access list to be configured.
48