D-Link DXS-3600 Series Cli Reference Manual page 67

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
-------------------------------------- ---------------
simple-ip-acl(ID: 3998)
simple-rd-acl(ID: 3999)
rd-mac-acl(ID: 6998)
rd-ip-acl(ID: 1998)
ip6-acl(ID: 12999)
park-arp-acl
Total Entries: 6
Switch#
This example shows how to display the IP access list called R&D.
Switch# show access-list ip R&D
IP access list R&D(ID:3996)
10 permit tcp any 10.20.0.0 0.0.255.255
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Switch#
This example shows how to display the content for the access list if its hardware counter is enabled.
Switch# show access-list ip simple-ip-acl
IP access list simple-ip-acl(ID:3994)
10 permit tcp any 10.20.0.0 0.0.255.255
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Counter enable on following port(s):
Ingress port(s): eth1/0/5-eth1/0/8
Egress port(s): eth1/0/3
Switch#
4-23 show vlan access-map
This command is used to display the VLAN access-map configuration information.
show vlan access-map [MAP-NAME]
Parameters
MAP-NAME
Default
None.
ip ext-acl
ip ext-acl
mac ext-acl
ip acl
ipv6 ext-acl
arp acl
(Ing: 12410 packets
(Ing: 6532 packets
(Ing: 8758 packets Egr: 4214 packets)
(Optional) Specifies the name of the VLAN access map being
configured. The name can be up to 32 characters.
62
Egr: 85201 packets)
Egr: 0 packets)