Table 7-56 Measurement Recorder > Signal Generation Settings Menu Description - Keysight U8903B User Manual

Signal generation
The signal generation is disabled if None is selected for the output configuration channel.
NOTE
The measurement recorder signal generation settings menu page is displayed as shown in
Figure 7-58.
Figure 7-58
Table 7-56 Measurement Recorder > Signal Generation settings menu description
Menu Description
Press the Waveform softkey to select the waveform type.
– Sine
Waveform – Variable Phase
– Square
– Arbitrary
Output Press the Output softkey to select the output channel.
Press the Waveform Config softkey to set the waveform configuration.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
Waveform Config
– Frequency
Set the frequency value.
– Amplitude
Set the amplitude value.
– DC Offset
Set the DC offset value.
Keysight U8903B User's Guide
Measurement Recorder > Signal Generation settings menu page
Test Sequence Application 7
391