Keysight U8903B User Manual page 460

A Appendixes
Table A-7 Analog analyzer menu tree description (continued)
Level 1 Level 2
Sample Size
Mov Average
Meas Config
Sync Average
Src Channel
Trigger Source
Trigger Edge
Connector
Impedance
Input Config
Auto Range
Range
460
Level 3 Description
– 2048
– 4096
– 8192
– 16384
– 32768
– 65536 Select the sample size.
– 131072
– 262144
– 524288
– 1M
– 2M
Set the number of measurement readings to be used for the moving
1 to 50
average calculation.
Set the number of points for the synchronous averaging in the analyzer
1 to 64
meter mode.
Select the internal generator channel as the reference channel used in the
following situations.
For the result calculation in unit dBg.
For the frequencies searching algorithm when the frequency lock is set to
Gen Lock.
– Free Run
Select the trigger source
– External
– Rising
Select the trigger edge type.
– Falling
– UnBal
– Bal Select the input connector type.
– Loopback
– 100 kΩ
(for UnBal)
Select the input impedance value.
– 200 kΩ
This setting is only available when the input connector is set to UnBal or
(for Bal)
Bal.
– 600 Ω
– 300 Ω
– On
Enable or disable the auto range.
– Off
– 140 V
– 100 V
– 32 V
Select the input voltage range value.
– 10 V
This setting is only available when the auto range is disabled.
– 3.2 V
– 1 V
– 320 mV
Keysight U8903B User's Guide