Perform Self-Test; Figure 1-8 System > Service > Self-Test Menu Page; Table 1-7 System > Service > Self-Test Menu Page - Keysight U8903B User Manual

1 Getting Started

Perform self-test

Perform the following procedure to run the U8903B self-test.
1 Press
2 From the System menu page, press the Service softkey.
3 From the Service menu page, press the Sel f-Test softkey. The Self-Test menu page is
displayed as shown in Figure 1-8.
4 Press the Customize Test softkey to select the desired tests.
5 Press the Run Test softkey to run the slected tests.
Figure 1-8
Table 1-7 System > Service > Self-Test menu page
Menu Description
Press the Customize softkey to select or deselect the desired tests.
Customize Test – LAN Test
– Card Self Test
Run Test Press the Run Test softkey to run the selected tests.
Clear Result Press the Clear Result softkey to clear the previous self-test results. The self-test results are saved in the system memory.
The System menu page is only available in the Standard mode. Refer to "Menu Key" on
NOTE
page
48
on the SYSTEM panel.
System > Service > Self-Test menu page
60 for more information on the U8903B available modes.
Keysight U8903B User's Guide