Table 7-32 Dfd Imd > Signal Generation Settings Menu Description - Keysight U8903B User Manual

Table 7-32 DFD IMD > Signal Generation settings menu description
Menu Description
Press the Waveform softkey to select the waveform type.
Waveform – IEC60118
– IEC60268
Output Press the Output softkey to select the output channel.
Press the Waveform Config softkey to set the waveform configuration. The available settings depend on the waveform
type.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
– Upper Freq
Set the upper frequency value.
Waveform Config
– Center Freq
Set the center frequency value.
– Diff Freq
Set the difference frequency value.
– Amplitude
Set the amplitude value.
– DC Offset
Set the DC offset value.
Signal analysis
The DFD IMD signal analysis settings menu page is displayed as shown in Figure 7-34.
Figure 7-34
Keysight U8903B User's Guide
DFD IMD > Signal Analysis settings menu page
Test Sequence Application 7
341