Table A-33 Measurement Settings > Receiver Sensitivity Menu Tree Description - Keysight U8903B User Manual

Receiver sensitivity
Table A-33 Measurement settings > Receiver Sensitivity menu tree description
Tab Level 1
Instrument
GPIB address
Start Power
Stop Power
Step Size
Dwell Time
Init Instrument
FM Frequency
Receiver Sensitivity
(Signal Generation)
FM Deviation
FM Rate
Init SCPI
Output Power SCPI
Meas Channel
Target SINAD
Min 1st Value
Receiver Sensitivity
(Signal Analysis)
Stop Condition
Freq Lock
Keysight U8903B User's Guide
Level 2 Level 3
– Keysight E4438C
– Other
– On
– Off
– Edit
– Import
– Until End
– On Target
– Auto
– Custom
Appendixes
Description
Select the signal generator model.
Set the GPIB address for the connected signal
generator.
Set the sweep start RF power.
Set the sweep stop RF power.
Set the step size.
Set the delay between each measured SINAD in
seconds.
Enable or disable the U8903B to send SCPI
commands to initialize the connected signal
generator.
Set the RF signal output frequency.
This setting is only available if Instrument is set to
Keysight E4438C and the Init Instrument is
enabled.
Set the RF signal frequency modulation deviation.
This setting is only available if Instrument is set to
Keysight E4438C and the Init Instrument is
enabled.
Set the RF signal internal frequency modulation
rate.
This setting is only available if Instrument is set to
Keysight E4438C and the Init Instrument is
enabled
Set the SCPI commands that initialize the
connected signal generator. You can set the SCPI
command directly or load from a file.
This setting is only available if Instrument is set to
Other and the Init Instrument is enabled.
Set the SCPI command that adjusts the RF power
of the connected signal generator.
Set the measured channel number.
Set the target SINAD value measured from the
Meas Channel.
Set the minimum first value.
Select the stop condition.
Select the searching method for the fundamental
frequency.
A
537