Example 4: Running the Test Sequence App for the multitone analyzer
measurement
In this example, you will learn how to use the Test Sequence App for the multitone analyzer
measurement in the U8903B.
1 Press
2 In the Project tab, press Add Measurement, and select Mul titone Analyzer to be added for
Test 1.
3 Press Settings to configure the multitone analyzer. For example, you can press Waveform
Config to set the amplitude, and press Tones Config to set the start and stop frequency.
4 The multitone measurement results can be displayed in a graph (Spectrum, Waveform,
Level, and Gain) and in a bar chart (Max Tone Level, Min Tone Level, TD+N Level, TD+N
Ratio, and Tone Level). Refer to "Multitone analyzer" on page
information.
5 Press
6 Depending on the settings parameter set for the multitone analyzer, the result will
return as PASS or FAIL and is shown as follows.
Figure A-14
Keysight U8903B User's Guide
to switch to Test Sequence App mode.
and select Start Test App to begin the test sequence.
Test Sequence App result for multitone analyzer
Appendixes
A
343
for more
577