Output Configuration (Digital Generator); Table 3-29 Digital Generator > Output Config Menu Description - Keysight U8903B User Manual

Output Configuration (Digital Generator)

The output configuration for the digital generator is displayed as shown in Figure 3-57.
Figure 3-57
Table 3-29 Digital Generator > Output Config menu description
Menu Description
Press the Connector softkey to select the output connector type.
– Bal
Connector Balanced mode outputs a digital signal on the XLR output connector at the U8903B rear panel.
– UnBal
Unbalanced mode outputs a digital signal on the BNC output connector at the U8903B rear panel.
AES Output Press the AES Output softkey to enable or disable the AES output.
Optical Output Press the Optical Output softkey to enable or disable the optical output.
Sample Rate Press the Sample Rate softkey to set the sample rate value.
Press the Aud io Format softkey to select the encoding audio format.
– Linear PCM
Aud io Format
– A-Law
– μ-Law
Press the Dither softkey to select the dither type. Dither is a noise component that can be superimposed on a signal.
– Off
Dither – Rectangular
– Triangular
– Shaped
Press the Ref Clock softkey to configure the reference clock settings. Refer to "Reference clock" on page
Ref Clock
information.
Press the Sync Clock softkey to configure the sync clock settings. Refer to "Sync clock" on page
Sync Clock
information.
Keysight U8903B User's Guide
Digital Generator > Output Config menu page 1
Audio Generator Functions
144 for more
145 for more
3
143