Msr Downlink Signal Measurement; Configuring The Measurement System - Keysight X Series Measurement Manual

Making MSR Measurements

MSR Downlink Signal Measurement

MSR Downlink Signal Measurement

The section describes how to make measurements for MSR Downlink Signal,
the measurement procedure with screen shots of the measurement example
are provided.
For the SCPI commands and detailed description of keys and parameters, refer to
N9083A MSR Measurement Application User's and Programmer's Reference.

Configuring the Measurement System

There are two kinds of measurement setups to test the DUT (Device Under
Test): Component Measurement System and Base Station Measurement
System.
Component Measurement System
This system is used for preamplifier and repeater. See the connection of the
equipment below.
Figure 2-1 Component Test System
1. Connect the RF Output of the Signal Generator to the Input port of the
2. Connect the Output port of the Component to the RF Input of the Signal
Base Station Measurement System
See the connection of the equipment below.
12
Component.
Analyzer.
Keysight N9083A & W9083A Measurement Guide