Keysight U8903B User Manual page 430

A Appendixes
Table A-4 Analog generator menu tree description (continued)
Level 1 Level 2
Amplitude
DC Offset
Waveform Config
(Abitrary)
Load File
Info
Amplitude
DC Offset
Start Freq
Stop Freq
Freq Spacing
Tones
Length
Waveform Config
(Multitone)
Custom
430
Level 3 Description
Set the signal amplitude value.
Set the signal DC offset value.
Load a waveform from a file.
Refer to "Append ix 13: Recall Menu Tree" on page
menu tree.
Display the loaded waveform information.
Set the signal amplitude value.
Set the signal DC offset value.
Set the lowest frequency in the multitone waveform which is usually the
frequency for the first tone.
Set the highest frequency in the multitone waveform which is usually the
frequency for the last tone.
– Linear
Select frequency spacing between the tones.
– Log
Custom is selected when the custom multitone waveform is set.
– Custom
Set the number of signal frequency components.
– 1024
– 2048
– 4096
Select the waveform length that determines the number of samples used to
– 8192
create one iteration of the multitone waveform.
– 16384
– 32768
– 65536
Apply the current setting on the selected tone for the custom multitone
Apply
waveform.
Optimize Optimize the crest factor for the custom multitone waveform.
Frequency Set the frequency value for the custom multitone waveform.
Amplitude Set the amplitude value for the custom multitone waveform.
Phase Set the phase value for the custom multitone waveform.
Add Above Add the tone above the selected tone for the custom multitone waveform.
Add Below Add the tone below the selected tone for the custom multitone waveform.
Remove Remove the selected tone for the custom multitone waveform.
Clear Clear all the tones in the custom multitone waveform list.
494 for the recall
Keysight U8903B User's Guide