Setting Up Measurement Signal (Frequency And Level); Selecting Measurement Range; Selecting Measurement Time - Keysight E4981A Programming Manual

Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
G:
Rp:
Rs:

Setting up measurement signal (frequency and level)

Setting up frequency
To select the measurement signal frequency (120 Hz/1 kHz/1 MHz), use the
following command.
•
Setting up level
To set the measurement signal level, use the following command.
•

Selecting measurement range

Selecting measurement range mode
To select the measurement range mode (auto range/hold range), use the
following command.
•
Selecting measurement range
To select the measurement range, use the following command.
•
The selectable measurement ranges differ depending on the measurement
signal frequency. Therefore, if a newly selected measurement frequency
conflicts with the current measurement range setting, the setting
automatically changes to cover the allowable range.
Setting up the measurement range automatically sets up the measurement
range mode to the hold range mode.

Selecting measurement time

To select the measurement time (1,2,4,6,8), use the following command.
•
42
Equivalent parallel conductance measured using the parallel
equivalent circuit model
Equivalent parallel resistance measured using the parallel
equivalent circuit model
Equivalent series resistance measured using the series
equivalent circuit model
:SOURce:FREQuency[:CW]
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]
[:SENSe][:FIMPedance]:RANGe:AUTO
[:SENSe][:FIMPedance]:RANGe[:UPPer]
[:SENSe][:FIMPedance]:APERture:TIME
on page 267
on page 265
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 268
on page 266
on page 253