Table 7-38 Smpte Frequency Sweep > Signal Generation Settings Menu Description - Keysight U8903B User Manual

7 Test Sequence Application
Table 7-38 SMPTE Frequency Sweep > Signal Generation settings menu description
Menu Description
Press the Waveform softkey to select the waveform type.
– SMPTE 1:1
Waveform
– SMPTE 4:1
– SMPTE 10:1
Output Press the Output softkey to select the output channel.
Press the Sweep Config softkey to set the sweep configuration.
– Swept
Select Upper Freq or Lower Freq as the sweep parameter.
– Start
Set the start value for the sweep parameter.
– Stop
Set the stop value for the sweep parameter.
– Spacing
Sweep Config Select Log, Linear, or Custom for the sweep spacing.
– Points
Set the number of sweep points.
– Step Size
Set the step size for linear spacing. This setting is only available when spacing is set to Linear.
– Dwell Time
Set the delay between the sweep points.
– Edit Points
Edit the individual points value, insert or remove points, load points, and save the points.
Press the Waveform Config softkey to set the waveform configuration.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
– Upper Freq
Waveform Config
Set the upper frequency value. This setting is only available if Swept is set to Lower Freq.
– Lower Freq
Set the lower frequency value. This setting is only available if Swept is set to Upper Freq.
– Amplitude
Set the amplitude value.
– DC Offset
Set the DC offset value.
352 Keysight U8903B User's Guide