Properties; Table 7-10 Tsa > Project > Test > Io Configuration > Properties Menu Description - Keysight U8903B User Manual

7 Test Sequence Application

Properties

The TSA > Project > Test > IO Configuration > Properties menu page is displayed as shown
in Figure 7-11.
Figure 7-11
Table 7-10 TSA > Project > Test > IO Configuration > Properties menu description
Menu Description
Name Press the Name softkey to rename the IO configuration.
Press the Sub-Steps softkey to configure the sub-steps settings. Refer to "Sub-steps" on page
Sub-Steps
on the sub-steps settings.
Press the Failure softkey to edit the failure message. If one or more measurements in the test sequence fails, the failure
Failure
message is displayed. The default message is "Failed". This setting is only available when Pass/Fail Msg is enabled.
306
Test > IO Configuration > Properties menu page
307 for more information
Keysight U8903B User's Guide