External Frequency Sweep; Table 7-42 External Frequency Sweep > Signal Generation Settings Menu Description - Keysight U8903B User Manual

7 Test Sequence Application

External frequency sweep

Refer to "Measurement Results" on page
menu page. Use the arrow keys to navigate through the respective tabs and to display the
menu page.
Signal generation
The external frequency sweep signal generation settings menu page is displayed as shown
in Figure 7-43.
Figure 7-43
Table 7-42 External Frequency Sweep > Signal Generation settings menu description
Menu Description
Press the Instrument softkey to select the instrument model.
– Keysight 33220A
– Keysight 33250A
Instrument
– Keysight 33500A
– Keysight 33600A
– Other
Press the GPIB Address softkey to select the GPIB address.
GPIB Address
– 0 to 30
Press the Init Instrument softkey to enable or disable the U8903B to send SCPI commands to initialize the connected
Init Instrument
signal generator.
Press the Init SCPI softkey to set the SCPI commands that initialize the connected instrument. You can set the SCPI
command directly or load from a file.
Init SCPI
– Edit
– Import (Refer to "Recall" on page
358
External Frequency Sweep > Signal Generation settings menu page
95 for more information on the Recall menu page.)
399 for more information on the respective result
Keysight U8903B User's Guide