Table 7-53 Receiver Sensitivity > Signal Analysis Settings Menu Description - Keysight U8903B User Manual

7 Test Sequence Application
Table 7-52 Receiver Sensitivity > Signal Generation settings menu description (continued)
Menu Description
Press the Init SCPI softkey to set the SCPI commands that initialize the connected signal generator. You can set the SCPI
Init SCPI command directly or load from a file. This setting is only available if Instrument is set to Other and the Init Instrument is
enabled.
Press the Output Power SCPI softkey to edit the SCPI command that adjusts the RF power of the connected signal
generator. The command must be in the following pattern.
Output Power SCPI
Cmds <val>
Cmds is the SCPI command and <val> is the value that will be filled up by the measurement to perform sweep. For
example, :POW <val>DBM. This setting is only available if Instrument is set to Other.
Signal analysis
The receiver sensitivity signal analysis settings menu page is displayed as shown in
Figure 7-55.
Figure 7-55
Table 7-53 Receiver Sensitivity > Signal Analysis settings menu description
Menu Description
Meas Channel Press the Meas Channel softkey to set the measured channel number.
Target SINAD Press the Target SINAD softkey to set the target SINAD value measured from the Meas Channel.
Min 1st Value Press the Min 1st Value softkey to set the minimum first value.
Press the Stop Cond ition softkey to select the stop condition.
Stop Cond ition – Until End
– On Target
382
Receiver Sensitivity > Signal Analysis settings menu page
Keysight U8903B User's Guide