Example 3: Generating A Multitone Waveform With The Analog Generator And Viewing The Multitone Spectrum In The Graph - Keysight U8903B User Manual

Example 3: Generating a multitone waveform with the analog generator and
viewing the multitone spectrum in the graph
In this example, you will learn how to generate a multitone waveform from the U8903B
analog generator and view the multitone spectrum in the U8903B graph.
1 Connect the analog generator unbalanced output to the analog analyzer unbalanced
input channel using a BNC cable.
2 Press
3 Press Waveform, and select Multitone as the waveform type.
4 Press Output Config > Connector, and select Unbalanced as the analog generator output
type.
5 Press Waveform Config > Amplitude, and set the amplitude to 1 Vrms.
6 Press Waveform Config > Start Freq, and set the start frequency to 937.5 Hz.
7 Press Waveform Config > Stop Freq, and set the stop frequency to 5.0625 kHz.
8 Press
9 Press
10 Press Input Config > Connector, and select UnBal as the analog analyzer input type.
11 Press
12 After you have completed the steps above, the U8903B display should look as follows.
Keysight U8903B User's Guide
on the FUNCTION panel to switch to audio generator mode, and press
on the FUNCTION panel to switch to analog interface.
to start the signal generation on the analog generator channel 1.
on the FUNCTION panel to switch to audio analyzer mode, and press
on the FUNCTION panel to switch to analog interface.
to start the signal measurement on the analog analyzer channel 1.
Appendixes A
575