Sub-Steps; Table 7-11 Sub-Step Menu Description - Keysight U8903B User Manual

Sub-steps

You can add any number of sub-steps to the measurement. The sub-steps can be enabled,
disabled, or deleted and moved into any order. You can add delay, prompts, and send SCPI
commands to the sub-steps. Press the Add Sub-Step softkey to add sub-step and press the
up and down arrow keys to select the desired sub-step.
The delay sub-step menu page is displayed as shown in Figure 7-12.
Figure 7-12
Table 7-11 Sub-step menu description
Menu Description
Press the Enable softkey to enable or disable the selected sub-step. The check box of the sub-step will be selected when
Enable
enabled.
Press the Add Sub-Step softkey to add sub-step to the list.
– Delay
Add Sub-Step
– Prompt
– Send SCPI
Delete Sub-Step Press the Delete Sub-Step softkey to delete the selected sub-step.
Ed it Press the Ed it softkey to move or copy the selected sub-step, or paste a copied sub-step after the selected sub-step.
Press the Settings softkey to configure the sub-step settings.
– Delay
Set the delay time in seconds.
Minimum: 0 s
Maximum: 3600 s (1 hour)
Settings
– Prompt
Refer to "Prompt sub-step settings" on page
– Send SCPI
Refer to "Send SCPI sub-step settings" on page
Properties Press the Properties softkey to rename the sub-step.
Keysight U8903B User's Guide
Delay sub-step menu page
Test Sequence Application
308 for more information.
309 for more information.
7
307