Dc Level - Keysight U8903B User Manual

Test Sequence Application 7

DC level

DC level measurement provides a single value measurement of the DC voltage present at
the output of each DUT channel. If AC coupling is selected in the input configuration
settings, it will change to DC coupling when the DC level measurement is being performed.
The DC level measurement settings allows you to configure the signal generation settings
and signal analysis settings.
The result for the DC level measurement for all the selected channels are displayed in a bar
chart (DC Level). Refer to "Measurement Results" on page 399 for more information on the
respective result menu page. Use the arrow keys to navigate through the respective tabs
and to display the menu page.
Signal generation
The signal generation is disabled if None is selected for the output configuration channel.
NOTE
The DC level signal generation settings menu page is displayed as shown in Figure 7-27.
Figure 7-27 DC Level > Signal Generation settings menu page
Keysight U8903B User's Guide 331