Appendix 15: Hp8903B Menu Tree; Table A-39 Hp8903B Menu Tree Description - Keysight U8903B User Manual

A Appendixes

Appendix 15: HP8903B Menu Tree

Table A-39 HP8903B menu tree description
Level 1 Level 2
Function
LP Filter
Measurement
HP/W Filter
Reference
Ratio
Format
Frequency
Generator Amplitude
Step Param
Freq. Step
Amp. Step
Generator
x 10
÷ 10
Freq. Start
Freq. Stop
Sweep
Sweep Status
552
Level 3 Description
– AC LEVEL
– SINAD
– DISTN
Select the HP8903B measurement mode.
– DC LEVEL
– SIG / NOISE
– DISTN LEVEL
– None
– 30 kHz Select the HP8903B measurement low-pass filter value.
– 80 kHz
Select the HP8903B high-pass or weighting filter value.
The filter selection depends on the left and right filters set at HP8903B
Config.
Set the reference value to be compared with the
measured value in ratio mode.
Changing the reference value will enable the measurement ratio mode.
– On
Enable or disable the HP8903B measurement ratio mode.
– Off
– Log
Select the HP8903B measurement format type.
– Lin
Set the HP8903B generator frequency value.
Changing the frequency value will also set the step parameter to frequency.
Set the HP8903B generator amplitude value.
Changing the amplitude value will also set the step parameter to
amplitude.
– Frequency
Select the HP8903B generator step parameter type.
– Amplitude
Set the HP8903B generator frequency step value.
This setting is only available when the step parameter is set to frequency.
Set the HP8903B generator amplitude step value.
This setting is only available when the step parameter is set to amplitude.
Multiply the current parameter step value by 10.
Divide the current parameter step value by 10.
Set the HP8903B sweep frequency start value.
Set the HP8903B sweep frequency stop value.
– On
Start or abort sweeping in the HP8903B mode.
– Off
Keysight U8903B User's Guide