Audio Generator Functions; Audio Generator; Figure 3-1 Analog Generator Menu Page; Table 3-1 Analog Generator Menu Description - Keysight U8903B User Manual

Audio Generator

Press
mode. The Analog Generator menu page, Digital Generator menu page, and Bluetooth
Generator menu page are displayed as shown in Figure 3-1, Figure 3-2, and Figure 3-3
respectively.
Press
interface.
Press
respectively and start configuring the active channel.
Press
the selected generator channel.
Figure 3-1
Table 3-1 Analog Generator menu description
Menu Description
Press the Waveform softkey to display the list of available analog generator waveform types. Select the desired waveform
Waveform
from the drop-down list.
Press the Waveform Config softkey to set the current active waveform configuration such as frequency, amplitude, and
Waveform Config
others. Refer to "Waveform Configuration" on page
Press the Output Config softkey to set the output configurations such as the connector type, impedance, and others. Refer
Output Config
to "Output Configuration (Analog Generator)" on page
Press the References softkey to configure the output references settings that are used in the unit conversion. Refer to
References
"References (Analog Generator)" on page
Keysight U8903B User's Guide
on the FUNCTION panel to switch between audio generator or audio analyzer
on the FUNCTION panel to switch between the analog, digital, and Bluetooth
or on the CHANNEL/DATA panel to switch to channel 1 or channel 2
on the RUN CONTROL panel to start or stop the signal generation for
Analog Generator menu page
171

Audio Generator Functions

102 for more information.
141 for more information.
for more information.
3
99