Table 6-1 Sweep Parameter Menu Description - Keysight U8903B User Manual

Table 6-1 Sweep Parameter menu description
Menu Description
Press the App. Type softkey to select the sweep application type.
– Sweep
App. Type
– Group Delay
This is only applicable for digital interface. Refer to "Group Delay" on page
This is only available when the sweep application type is Sweep.
Parameter
Press the Parameter softkey to select the sweep parameter type. The parameter selection depends on the waveform type
set at the analog generator.
Press the Points Settings softkey to configure the sweep point parameters such as start, stop, step size, point count, and
Points Settings spacing.
Refer to "Points settings" on page
Dwell Time Press the Dwell Time softkey to set the delay in ms for the generator to output the signal.
Press the Sweep Mode softkey to select the sweep mode.
– Continuous
Sweep Mode Sweep all points.
– Single
Sweep point by point.
Press the Channels softkey to set the sweep channels.
Channels Refer to "Sweep channels" on page
disabled.
Press the Plot View softkey to display the Plot View menu page.
Plot View
Refer to "Plot View" on page
Keysight U8903B User's Guide
283 for more information.
284 for more information. This setting is only available when the legacy sweep is
285 for more information.
Sweep Function
282 for more information.
6
281