Keysight U8903B User Manual page 435

Table A-5 Digital generator menu tree description (continued)
Level 1 Level 2
Waveform Config
Custom
(Multitone)
Amplitude
DC Offset
Waveform Config
(Abitrary)
Load File
Info
Connector
AES Output
Optical Output
Sample Rate
Output Config
Audio Format
Dither
Keysight U8903B User's Guide
Level 3 Level 4
Apply
Optimize
Frequency
Amplitude
Phase
Add Above
Add Below
Remove
Clear
– Bal
– UnBal
– On
– Off
– On
– Off
– Linear PCM
– A-Law
– μ-Law
– Off
– Rectangular
– Triangular
– Shaped
Appendixes
Description
Apply the current setting on the selected tone for
the custom multitone waveform.
Optimize the crest factor for the custom multitone
waveform.
Set the frequency value for the custom multitone
waveform.
Set the amplitude value for the custom multitone
waveform.
Set the phase value for the custom multitone
waveform.
Add the tone above the selected tone for the
custom multitone waveform.
Add the tone below the selected tone for the
custom multitone waveform.
Remove the selected tone for the custom
multitone waveform.
Clear all the tones in the custom multitone
waveform list.
Set the signal amplitude value.
Set the signal DC offset value.
Load a waveform from a file.
Refer to "Append ix 13: Recall Menu Tree" on
page 494 for the recall menu tree.
Display the loaded waveform information.
Select the output connector type.
Enable or disable the AES output.
Enable or disable the optical output.
Set the sample rate value.
Select the encoding audio format.
Select the dither type.
A
435