Table A-32 Measurement Settings > Dc Level Sweep Menu Tree Description - Keysight U8903B User Manual

DC level sweep
Table A-32 Measurement settings > DC Level Sweep menu tree description
Tab Level 1
Output
Sweep Config
DC Level Sweep
(Signal Generation)
Sweep Config
DC Level Sweep
LPF
(Signal Analysis)
Keysight U8903B User's Guide
Level 2 Level 3
Start
Stop
Spacing
Points
Step Size
Dwell Time
Point No
Point Value
Insert Point Above
Insert Point Below
Remove Point
Clear
Edit Points
Reverse Order
Sort
Load Points
Save Points
– None
– 2 kHz
– 3 kHz
– 5 kHz
– 8 kHz
– 10 kHz
– 15 kHz
– 20 kHz
– 22 kHz
– 30 kHz
– 40 kHz
– 50 kHz
– 80 kHz
– Custom
Appendixes
Description
Select the output channel.
Set the start value for the sweep parameter.
Set the stop value for the sweep parameter.
Select Log, Linear, or Custom for the sweep
spacing.
Set the number of sweep points.
Set the step size for linear spacing. This setting is
only available when spacing is set to Linear.
Set the delay between the sweep points.
Set the point number.
Set the point value.
Insert a point above the selected point.
Insert a point below the selected point.
Remove the selected point.
Clear all points.
Reverse the order of the points.
Sort the points in ascending order.
Load points from a file.
Refer to "Append ix 13: Recall Menu Tree" on
page 494 for the recall menu tree.
Save the points to a file.
Refer to "Append ix 12: Save Menu Tree" on
page 493 for the save menu tree.
Select the low-pass filter.
A
535