Measurement Example Signal Settings; Measurement Procedure; Viewing Channel Power Measurement Results - Keysight X Series Manual

Making WLAN Measurements
Making Channel Power Measurements

Measurement Example Signal Settings

Measurement Procedure

Step
1. Select WLAN Mode.
2. Preset the analyzer.
3. Select the desired radio
standard.
4. If necessary, select the
frequency settings.
5. Select the measurement.
6. Examine the keys that are
available to change
measurement
parameters from their
default conditions.
7. Select the channel power
measurement again or
restart the measurement.

Viewing Channel Power Measurement Results

Measurement results available include a graphical window and a text window
showing the absolute power and its peak power spectral density values over 1
MHz integration bandwidth.
For more information on what these data are, see the N9077A & W9077A
WLAN Measurement Application User's and Programmer's Reference.
Click to Go Back to
22
Frequency: 2412 MHz
Output Power: -30 dBm (at analyzer input)
WLAN signal radio standard: 802.11n/40 MHz
Data Rate: 270 Mbps 64 QAM
Action
MODE WLAN
a. Press ,
Mode Preset
a. Press
factory preset.
b. To recall a user-defined Preset:
User Preset
Press
preset the current mode.
MODE Setup
a. Press
802.11n 802.11n (40 MHz)
,
FREQ Channel
a. Press
MEAS Channel Power
a. Press ,
Meas Setup,
a. Press
parameters you want to change and
input your settings.
Meas, Channel Power
a. Press
Restart
press .
"Making Channel Power Measurements" on page
Notes
.
button for the
User Preset
, to
Rad io Std
, ,
.
2412 MHz
, , .
.
PSD Limit
then select the If
limit test always shows Pass.
, or
Keysight WLAN Measurement Guide
Off
is set to , the
21.