Keysight U8903B User Manual page 487

Table A-10 Graph analysis menu tree description (continued)
Level 1 Level 2
Window
Graph Settings
Sync Avg
Hold
Axis
Enabled
Left
Right
Span
Axis Settings
Center
Top
Bottom
X-Scale
Y-Scale
Active Trace
Source
Enabled
Trace Settings
Memory
Keysight U8903B User's Guide
Level 3 Description
– Rectangular
– Hanning
– Blackman
– Rife-Vincent
Select the window function to be applied to the data before the FFT
process.
– Rife-Vincent 3
– Hamming
– Flat Top
– Kaiser
Set the number of samples to be acquired and averaged before the FFT
1 to 64
process is performed.
– None
– Average
Select the type of hold to be performed after the FFT process.
– Min
– Max
– Primary
Select the active axis to be configured.
– Secondary
Enable or disable the axis settings.
– On
This setting is only available when the axis type is secondary. If the axis
– Off
type is primary, this setting is always set to On.
Set the left axis limit value.
Set the right axis limit value.
Set the total X-axis span or total range to be monitored in the graph.
Set the X-axis center point in the graph.
Set the top axis limit value.
Set the bottom axis limit value.
– Linear
Select the X-axis scale type.
– Log
– Linear
Select the Y-axis scale type.
– Log
1 to 8 Select the active trace channel.
Select data source of the active trace from the available channels, traces,
files, and memory.
– On
Enable or disable the active trace data.
– Off
Save To Memory Save the active trace to the memory buffer.
Load From Memory Load a trace from the memory buffer into the active trace.
Clear Memory Clear the trace from the memory buffer.
Appendixes A
487