Crosstalk - Keysight U8903B User Manual

7 Test Sequence Application

Crosstalk

Crosstalk is the unwanted leakage or bleed of a signal from one or more channels to other
channels in a DUT. Crosstalk measurement provides the measurement of the crosstalk into
the unstimulated DUT channel(s) when one channel is stimulated.
The generator will output the test signal to the DUT on the selected driven channel. The
crosstalk in each of the remaining channels is then measured. The crosstalk measurement
settings allows you to configure the signal generation settings and signal analysis settings.
The crosstalk measured in each channels are displayed in a bar chart (Crosstalk). Refer to
"Measurement Results" on page
page. Use the arrow keys to navigate through the respective tabs and to display the menu
page.
Signal generation
The signal generation is disabled if None is selected for the output configuration channel.
NOTE
The crosstalk signal generation settings menu page is displayed as shown in Figure 7-29.
Figure 7-29
334
399
Crosstalk > Signal Generation settings menu page
for more information on the respective result menu
Keysight U8903B User's Guide