Sweep Parameter - Keysight U8903B User Manual

6 Sweep Function

Sweep Parameter

The U8903B sweep mode is only available in the Standard View mode. Refer to "Menu Key"
NOTE
on page
The U8903B sweep mode allows you to perform sweeps and to display the results in a plot
view. Press
Parameter menu page is the default page and is displayed as shown in Figure 6-1.
There are three main panels on the Sweep Parameter menu page. The top panel displays
the current sweep settings and the bottom panels display the audio generator and audio
analyzer settings respectively. Press
analog and digital interface. Use the arrow keys to navigate among the panels.
Press
mode.
Figure 6-1
280
60 for more information.
on the FUNCTION panel to access the sweep mode. The Sweep
on the RUN CONTROL panel to start or stop the sweep in the sweep
Sweep Parameter menu page
on the FUNCTION panel to switch between
Keysight U8903B User's Guide