Sweep Channels; Table 6-3 Sweep Parameter > Channels Menu Description - Keysight U8903B User Manual

Performance audio

Hide thumbs Also See for U8903B:

Table of Contents

Sweep Function

Sweep Parameter > Points Settings menu description (continued)

Press the Points softkey to set the sweep points value. Adjusting the sweep points value will change the sweep step value.

This setting is only available when the sweep spacing is Log or Linear.

Press the Ed it Points softkey to configure the sweep points.

Ed it Points

Refer to "Ed it Points" on page

be set to Custom.

Sweep channels

This setting is only available when the legacy sweep is disabled.

Sweep Parameter > Channels menu description

Press the Source softkey to select the source channel(s).

Press the Measure softkey to select the measure channel(s). The available selection depends on the number of installed

analog analyzer cards.

for more information. If the sweep points are changed, the sweep spacing mode will

Sweep Parameter > Channels menu page

Keysight U8903B User's Guide

Table of Contents